Full Stage 2 Package for Ford Focus ST 225. This is a Drive In- Drive Out package from standard to around 300bhp non block modded, or 320bhp if proof of block mod can be supplied. Our package contains: Full 3" turbo back Scorpion non-resonated exhaust system with downpipe and de-cat. Airtec Stage 2 intercooler. Focu ST on the German Autobahn!A little try for top speed but didn´t make it due traffic.Dreamscience Stratagem Ultra.Race + tune.All others stock! 5: 0.943 x 2.773. 6: 0.789 x 2.773. R: (1.413 x 3.583) x 2.773 . Note: The stated fuel consumption and CO 2 emissions are measured according to the technical requirements and specifications of the European Regulation (EC) 715/2007 as last amended. Results in MPG also correspond to this European drive cycle and are stated in imperial gallons. We'll explain what modifications it takes to achieve certain power levels with the Mk2 Focus ST225 and the power at each stage of tuning. My car is currently stage 2.5. I have all the stage 3 mods except RS injectors and a stage 3 map. Currently I run DSCI which is really stage 1 or 2 but I figured if I've got all the mods to run a higher power map then I should go for it. I have narrowed it down to 3 maps and I will explain why: I am planning on getting an AP and going stage 2. Cobb says this requires their intake, a rear motor mount and either their intercooler, or a similarly specced one. But I keep hearing people say intakes are overrated and a drop in filter will eliminate most of the stock restriction. Hi all My Focus st is running around approx 300bhp. I'm looking at putting a Airtec Intercooler onto it but not sure which one, either a Stage 1 or Stage 2. Im NOT looking at going onto a stage 2 remap as I'm happy as it is but just looking at which will be the best choice of intercoolers AIRTEC TWO-PIECE BREATHER SYSTEM – MK2 ST & RS. Select Options. BMW F8X M2/M3/M4 MST Performance Induction Kit. Select Options. Upgrade your Focus RS MK3 with our Stage 2 modifications and DS Ultima 3 installation. Expect to see 403bhp & 435ftlbs with our Focus RS MK3 Tuning & Remaps. Suspecting the original stage 1 map might not be suitable as i did not know who put it on or what the map was like, i decided to visit my local tuner today and put a stock base map on the car. This ran much much better with no boost cut but obviously made far less boost (around 0.5-0.6 bar is about right for the standard map on these i believe). kIhH.

focus st mk2 stage 2 requirements